It doesn’t matter whether your car window gets stuck down or up; it’s a nightmare to drive with a manual car window that doesn’t roll-up. The window that won’t roll down is better than that that can’t roll-up. What if it starts to rain abruptly? That’s when the situations worsen.
This article tries to enlighten you on fixing a manual car window that won’t roll-up. Whether your car windows are manual or automatic, there is always a solution to such issues. If you are clever or lucky, it’s possible to have your window roll up again without employing special tools.
How do manual car windows operate?
Car window operates with the aid of a component known as a regulator for lowering and raising them inside. Manual windows are equipped with physically attached regulators to cranks. Rotating the crank will reduce or raise the window.
Therefore, manual car windows may fail to work correctly due to mechanical damages. Sometimes, the gears on the crank or regulator may wear out or bend the regulator. Besides, the regulator may get stuck as a result of friction; lubricating grease might be out.
Fixing car manual windows that don’t roll up
Nature or manual windows are more straightforward compared to power windows. Because there are no electronics included, there are mainly two components that might have gone wrong, hindering the window’s typical performance. The faulty regulator, and the worn crank gears are the two most likely culprits. Try to apply some grease to the car window that won’t roll up and see if it works.
However, fixing a car manual window can be tricky because you can’t temporarily force the stuck window up. Sometimes you may even push the window to its correct position, but the actions continue to worsen the status. You can also break the car window regulator.
To determine why your car manual window isn’t rolling up, you will have to remove or take out the door panel and window crank. You can visually inspect everything. Use this detailed guide to have the issue fixed:
Step 1: Check the window crank
Try to rotate the window handle while paying much attention to notice how it behaves. If the crank turns freely, or feels like it’s grinding, its teeth may be damaged. They may be removed from the crank. On such occasions, you are supposed to take out the crank and diagnose defects visually.
If the teeth are stripped in the crank, the best and permanent solution is to replace the whole door handle. Replacing the crank is simple, but you need to ensure the new one is compatible with the existing door handle. Else, you may end up fixing the wrong handle that will start to behave strangely sooner than expected.
If you have checked the crank’s status and realized it’s good, you’ll have to move to the next step that involves removing the door panel.
Step 2: Detach the door panel
The first thing to do is to unscrew the door panel so that you access internal parts of the window. You need to grab all the available screws that are located at the back of the door handle. Try to separate the plastic rivets, but with a lot of care.
Remove all the screws from the manual window and check for any extra screws. Once the door panel is off, go through the sheet metal’s opening and access the window crank and pulley.
Step 3: Check the position of the window’s glass
Under this step, you need to ensure that the window’s glass is in good working condition. Sometimes these glasses get dislodged from their track, or they can be stuck to one side. When cranking, the window won’t roll-up.
You should check that the tracks are in good condition. They tend to loosen over time, so tightening is necessary to fit the glass properly.
Step 4: Inspect the operation and connection of the car window crank
The crank plays a critical role in the manual window as they act as the switch in the automatic car windows. The problem with the connection of the crank to the car window crank can sometimes be serious. This could cause problems in the overall performance of your car’s windows.
On occasions where the crank’s operation doesn’t move the arms, your car window won’t raise. In such scenarios, you will be required to replace the entire pulley of the window system. It’s difficult to replace the faulty mechanical part when it comes to the pulley system.
Step 5: Check the condition of the regulator
A faulty regulator might be another reason your manual car window isn’t rolling up. This could be a faulty component that has dried out grease or got stuck. Applying some oil to the regulator or removing it can solve the problem.
What you need to ensure is that the regulator operates smoothly to roll up the window.
Step 6: Check the car window alignment
Sometimes the window of your car might have popped out of its track. Believe me, and you won’t roll it up. On occasions where the window is out of its channel, twist it to restore its normal position. This act can be the simplest solution if it’s your lucky day. Before you try to diagnose more problems,
Frequently asked questions:
- What are the causes of “window won’t Roll Up”?
This issue can be caused by many things. The simplest of them can be a fuse or dead battery. Occasionally, it could be something complicated that is tricky to access. These include; a faulty switch, melted wire, lousy window motor, among other causatives that could lead to permanent or intermittent issues.
- How Can I force the window open on my car?
With the car door open, use your palms to hold the window together. This procedure requires a helper who will be in charge of operating the window switch. Try to lift up the window by exerting some small amount of energy between your palms. Sometimes you may be forced to grip the car window from the top to apply enough pressure. If it’s your lucky day, the window will roll up again. Drive the vehicle to the nearest automotive shop for diagnosis.
- What lubricants do I need to use on my car’s windows?
WD-40 continues to be the best and most qualified staff for different purposes. You will also find people using Silicone spray to clean their window channels. The cheapest option is soap or wax, but it can lead to buildup that eventually affects the window’s regular operation. I am sure no one would wish to get his/her car window(s) to this extent.
Conclusion
Even after trying the above steps, the problem can persist; it’s normal, and you should not worry. Experts recommend referring to the manual or seeking help when the ‘Manual Car Window That Won’t Roll Up’ issue. These are jobs you can attempt yourself by following the above guide.
However, if you have tried everything, but the car window is not responding, contacting a specialist can be the best solution. Specialists can diagnose problems faster than you, and sometimes they even touch the vehicle. Though, expect to pay some amount for the service; nothing comes for free.
